Page 1 of 1

Which Tactrix cable do I need?

Posted: Sun Jan 30, 2011 10:50 am
by hackish
The Lancer Ralliart can be reflashed with our software using the following cable:
http://www.tactrix.com/index.php?page=s ... &Itemid=53

You also need the Mitsubishi reflash adapter:
http://www.tactrix.com/index.php?page=s ... &Itemid=53

It is possible to rewire the OBD2 port to provide the programming signal on the OBD2 connector. Instructions on this will be posted at a later date.

-Michael

Re: Which Tactrix cable do I need?

Posted: Mon Feb 27, 2012 2:15 am
by cranswick
When you reflashed my ECU last spring, you rewired my OBD2 port, right?

I'll be using a friend's cable, he's got an 09+ Ralliart...

Re: Which Tactrix cable do I need?

Posted: Mon Feb 27, 2012 9:20 am
by hackish
I think I did but I don't remember.

-Michael

Re: Which Tactrix cable do I need?

Posted: Wed Feb 29, 2012 12:14 am
by cranswick
what would it look like? i just want to make sure before i go buy that mitsubishi adapter dongle...

Re: Which Tactrix cable do I need?

Posted: Fri Mar 16, 2012 7:07 am
by hackish
There would be a wire going from the little white plug to a new pin in your OBD2 port. I think it's pin 11.

-Michael

Re: Which Tactrix cable do I need?

Posted: Mon Mar 26, 2012 2:10 pm
by cranswick
ok, yes there is an orange wire spliced from the green wire in the white connector to a pin in the OBD2 port, not sure about the pin layout but it looks like you did modify it, so just the open port 2.0 is required to flash the ROM, thanks for the help.

-Garrett

Re: Which Tactrix cable do I need?

Posted: Sun Apr 01, 2012 8:36 am
by hackish
With the software, yes. It's better if you email me your VIN first so I can enter it into the server. Otherwise there is another step in getting it working - I have to approve the request before you can read the ECU.

-Michael

Re: Which Tactrix cable do I need?

Posted: Sun Apr 01, 2012 1:01 pm
by cranswick
Awesome, thanks