Logging your wideband output with FastWorks

Post Reply
hackish
Site Admin
Posts: 588
Joined: Wed Jan 05, 2011 1:49 pm

Logging your wideband output with FastWorks

Post by hackish » Tue Jan 22, 2013 12:41 pm

The majority of wideband gauges have an analog output. This output can be wired to your OBD2 plug so you can log the vehicle's air/fuel ratio with all the other engine parameters. You will need to consult the owner's manual for your gauge to determine which wire gives the 0-5v output. You need what's called a linear output instead of a narrowband simulation. This wire needs to be connected to Pin 8 on the OBD2 connector. The female pins will depend on the vehicle as there are 4-5 different manufacturers of OBD2 female plugs found in vehicles. I recommend visiting your local scrapyard to harvest a plug so you can get the correct female pins. If you know who makes the housing you can generally order the pins from an electronics supply house such as DigiKey.
obd2plug.jpg
Bosch style OBD2 connector
obd2plug.jpg (180.86 KiB) Viewed 6823 times
This is a Bosch connector housing. It is used on the majority of european cars as well as the Lotus.
obd2pin.jpg
Corresponding pin
obd2pin.jpg (49.78 KiB) Viewed 6823 times
This is the corresponding pin for that connector.

-Michael

hackish
Site Admin
Posts: 588
Joined: Wed Jan 05, 2011 1:49 pm

Re: Logging your wideband output with Fastworks

Post by hackish » Thu Jul 18, 2013 7:26 pm

aem.png
aem.png (8.72 KiB) Viewed 6482 times
I've added the AEM directions for those who have not been able to find their documentation for an AEM UEGO gauge. Please note the analog ground (brown) must be connected and the white wire 0-5v output goes to the obd2 plug.

-Michael
Attachments
aem-30-5130-installation-instruction.pdf
(602.15 KiB) Downloaded 360 times

hackish
Site Admin
Posts: 588
Joined: Wed Jan 05, 2011 1:49 pm

Re: Logging your wideband output with FastWorks

Post by hackish » Thu Oct 17, 2013 9:28 am

I have tested and found that the bosch female terminal will go into the mitsubishi plug.

Canada
http://www.digikey.ca/product-detail/en ... ND/2405657
USA
http://www.digikey.com/product-search/e ... M3324CT-ND

The digikey part number is WM3324CT-ND

-Michael

hackish
Site Admin
Posts: 588
Joined: Wed Jan 05, 2011 1:49 pm

Re: Logging your wideband output with FastWorks

Post by hackish » Thu Mar 20, 2014 9:37 am

Glowshift widebands, I don't recommend them because of accuracy issues but here are the instructions:
http://www.glowshift.com/instructions/7 ... atalog.pdf

Should be the brown 0-5v wire.

-Michael

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest